LicenseServer1.6 is the systems,which is usedtomanagelicensesinsoftwareproducts based on the 1C enterprise.. It is usuallyinstalledon1 PC,whichis the serveror the main PCthe server, where database is located.
Aftersomeactionswith the server or the main PC (for example , - a sudden reboot of the server, adding memory to the server, etc.), the errorsmayoccur. Themostcommon errors andsolutions are listed below:
...
1) Open the license server (located at the server or main PC):
2) Click connect:
3) Check is there active license or not (green - active, red - inactive):
...
4) By the instruction License Request Process in FirstBit get the registration key and send it to Hotline:
5) Get the license from Hotline and apply it:
. After processing, you will receive a new license and be able to apply it.
b) Problem: An error occurred during connection to the License Server 1.6 through Licence Service Assistant service. By Reason Of: Could not connect to the license server assistant:
Solution:
1) Check point Perform the check described in (a)
If 2)IIf the license is active :2) Check — verify the server name or IP address:
Case 1: error at Error on the server or main PC:
Common settings should have License server's IP address:
IP address is the same that shown at License server itself:
...
In the general settings, the IP address of the License Server must be specified.
It should match the one shown in the License Server itself.
The IP address can also be written as localhost.
Case 2: error at other PC, where the is no license server:Common settings should have server's or main PC's Name or Error on another PC (without License Server installed)
In the settings, you must specify either the server name or server IP address:
How to find it:
NAME: Find Server's or main PC's Name in PC's properties:Server name can be found in PC properties
IP ADDRESS: Find server's or main PC's IP address by command CMD:
Text Ipconfig, press Enter and get the IP:
3) License server Assistant Service Port put 10602, if it is not working, try 10600 and 10601:
...
IP address can be obtained via the CMD command: ipconfig
3)IIf the server name or IP address are correct — check the License Server Assistant Service port. Default port: 10602, if it does not work, try 10600 or 10601.
4)Make sure the Jackdaw checkbox is enabled (this setting is only available on the server but affects other PCs).
Thank you for being a FirstBIT customer!